Table of Contents
Advertisement
Introduction
Sensor Guard Weights
To help stabilize the sensors when profiling at deeper depths, a 1 lb. sensor guard weight is supplied with 4 port
assemblies 10 meters and longer. To attach the weight, carefully hand-tighten it clockwise on to the bottom of the
sensor guard
(Figure 6 on page
11).
NOTICE: If any resistance is felt, loosen the sensor guard weight completely to prevent cross-threading.
Incorrect installation may cause damage to the sensor guard.
The bottom of the weight is threaded so that additional weights can be added if needed. See
ProDSS accessories on
page
80.
NOTE: Do not have any weights installed on the sensor guard when calibrating using the calibration cup.
12
Advertisement
Table of Contents
