Transport And Storage; Scope Of Supply; Transport - Siemens FLENDER B3 E Series Assembly And Operating Instructions Manual

Belt conveyor gear unit, sizes 4 to 28
Table of Contents

Advertisement

4.

Transport and storage

Observe the instructions in section 3, "Safety instructions"!
4.1

Scope of supply

The products supplied are listed in the despatch papers. Check immediately on receipt to ensure that all
the products listed have actually been delivered. Parts damaged and/or missing parts must be reported
to Siemens in writing immediately.
If there is any visible damage, the gear unit must not be put into operation.
4.2

Transport

When transporting our products, use only lifting and handling equipment of sufficient
load­bearing capacity!
Observe the notes regarding load distribution on the packing.
The gear unit is delivered in the fully assembled condition. Additional items are delivered separately
packaged, if applicable.
Different forms of packaging may be used, depending on the size of the unit and method of transport.
Unless otherwise agreed, the packaging complies with the HPE Packaging Guidelines.
The symbols marked on the packing must be observed at all times. These have the following meanings:
Top
Fig. 2:
Transport symbols
Transport of the gear unit must be carried out so as to avoid personal damage and
damage to the gear unit.
If, for example, the free shaft ends are knocked, this may damage the gear unit.
The gear units must be transported with suitable equipment only.
During transport the gear units should be left without oil filling and on the transport packaging.
The instructions for the add­on auxiliary drive unit must be observed.
Exception: In the case of gear units with auxiliary drive, the auxiliary gear unit will be delivered
ex works with oil filling.
Use only the eyes provided to attach lifting equipment to the unit.
Handling of the gear unit by attaching it to the piping is not permitted.
The pipework must not be damaged.
Do not use the front threads at the shaft ends to attach slinging and lifting gear for
transport.
Slinging and lifting gear must be adequate for the weight of the gear unit.
Fragile
Keep dry
BA 5033 EN 03/2011
Keep cool
Centre of
gravity
18 / 96
Use no hand
Attach
hook
here

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents