Clean The Oil Filter; Clean The Air Filter; Clean The Fan And Gear Unit; Refill Taconite Seals With Grease - Siemens FLENDER B3 E Series Assembly And Operating Instructions Manual

10.2.3 Clean the oil filter

For operation and maintenance, always observe the operating instructions indicated in the
order­specific appendix.
For technical data, refer to the order­specific list of equipment.

10.2.4 Clean the air filter

If a layer of dust has built up, the air filter must be cleaned, whether or not the minimum period
of 3 months has expired.
Unscrew the air filter including the reducing screw.
Clean the air filter using benzine or a similar cleanser.
Dry the air filter and/or blow with compressed air.
Be especially careful when blowing with compressed air.
Wear protective glasses!
Foreign bodies must be prevented from entering the gear unit.

10.2.5 Clean the fan and gear unit

The instructions in item 5.10.1 must be observed!
Remove the fan cowl.
Using a stiff brush, remove any dirt adhering to the fan wheel, fan cowl and safety grid.
Remove any corrosion.
Screw safety grid back onto the fan cowl.
It must be ensured that the air guide cover is correctly fastened. The fan must not come
into contact with the air guide cover.
To prevent the build­up of dust on the gear unit, cleaning must be done in accordance
with operating conditions.
The gear unit must not be cleaned with high­pressure cleaning equipment.

10.2.6 Refill Taconite seals with grease

Inject approx. 30 g lithium­based rolling­bearing grease into each of the lubrication points of the
Taconite seal. The lubricating point have been provided with a flat grease nipples. For the exact
arrangement of the grease nipples, refer to the drawings in the gear­unit documentation.
Remove and dispose of any old grease escaping.
BA 5033 EN 03/2011
89 / 96