Table Of Contents - Dell Networking C9010 Getting Started Manual

Table Of Contents

Notes, Cautions, And Warnings2
About This Guide3
C9010 Hardware Description4
Unpacking The Switch5
Before You Start: Site Preparation6
Installing The Hardware7
Installing The Chassis In A Two-Post Threaded-Hole Rack7
Installing The Chassis In A Four-Post Rack11
Using Dell Readyrails (Optional)14
Installing Readyrails: Tool-Less Method For A Non-Threaded-Hole Rack16
Installing Readyrails: Tooled Method For A Threaded-Hole Rack19
Using A Rack Mount Tray (Optional)21
Securing The Chassis Ground22
Installing A Fan Tray23
Installing Rpms And Line Cards24
Installing An Rpm25
Installing A Line Card27
Installing A Power Supply28
Psu Installation Guidelines29
Psu Installation Procedure29
Installing The Cable Management System30
Installing The Qsfp+ And Sfp+ Optics33
Powering Up The System34
Before Powering Up34
Power-Up Sequence34
Checking Led Status35
Configuring The Software40
C9010 Console Ports40
Setting Rj45 Console Access41
Rj45 Cable And Adapter Pin Assignments41
Setting Usb-B Console Access43
Initial Software Configuration43
Command Modes44
Configuring The Enable Password44
Configuring A Host Name45
Port Numbering45
Configure Layer 2 (Data Link) Mode45
Accessing The System Remotely46
Configuring The Management Port Ip Address46
Configuring A Management Route46
Configuring A Username And Password47
Splitting Qsfp+ Ports Into Sfp+ Ports47
Creating A Vlan47
Connecting The Switch To The Network48
Dell Networking Support50
Technical Specifications52