Dell Networking C9010 Getting Started Manual page 9

Hide thumbs Also See for Networking C9010:

Table of Contents

Figure 3. Removing Brackets from the Chassis

Use an equipment lift or ask two people to lift the chassis and align the rack-mount screw holes on

each flange of the chassis with the holes in the equipment rack (Figure 4). Rest the chassis on top of

the rack bar (or the rack tray or ReadyRails, if installed). Slide the chassis so that the holes in the side

flanges align with the holes in the rack posts. Tighten the two thumb screws (item 2 in Figure 4) and

four rack screws (item 3 in Figure 4) provided by the rack manufacturer on each chassis flange to

attach the chassis to the rack posts.

Installing the Hardware

Table of Contents