Table of Contents
Advertisement
Figure 26. Cable Management Brackets Installed on Chassis
3.
To open part of a cable bracket, pull one of the latches forward so that it swings down.
4.
To remove a cable bracket, push up the blue button located in the center of a bracket to release it.
When you cable C9010 ports, be sure not to interfere with the airflow from the ventilation holes on the
right and left sides of the chassis.
Do not remove the cable management brackets with installed cables. First unplug and remove all cables,
then remove the brackets.
Installing the QSFP+ and SFP+ Optics
The C9010 switch may use 40G QSFP+ and/or 1/10G SFP+ optical ports. You can use a breakout cable in
a 40G QSFP+ port to split it into 4 SFP+ optical ports.
For a list of supported optics, refer to the data sheet at [Add link from Harish/Mike Chow].
CAUTION: ESD damage can occur if the components are mishandled. Always wear an ESD-
preventive wrist or heel ground strap when handling the switch and its components.
Installing the Hardware
33
Advertisement
Table of Contents
