Table of Contents
Advertisement
Installing ReadyRails: Tool-less Method for a Non-Threaded-Hole Rack
To install ReadyRails using a tool-less method in a non-threaded 4-post rack:
1.
Attach the chassis rails on the right and left sides of the chassis.
•
Remove the two chassis rails from the Dell ReadyRails kit.
•
Align the holes on the right and left chassis rails with the screws at the bottom of each side of the
chassis (orange arrows and item 1 in Figure 10).
•
Press each chassis rail over the screws and slide it backwards (towards the back of the chassis) so
that it snaps securely into place (blue arrows and item 2 in Figure 10).
Figure 10. Installing Chassis Rail for Toolless Ready Rail Installation
2.
Attach a spacer to the back of each chassis flange as shown in Figure 11. The spacers allow the
flanges to be attached flush to each rack post.
Place each spacer over the four pins at the back of each chassis flange. Then slide each spacer down
so that it locks into place and is flush with the flange.
16
Installing the Hardware
Advertisement
Table of Contents
