Table of Contents
Advertisement
DALì LINER PLUS
TOP UP HYDRAULIC OIL
With each start up, check the hydraulic oil level by looking through
the gauge (L1) on the side of the; If necessary, use "AGIP OSO
46 type hydraulic oil" to top up the level.
L1
REPLACING HYDRAULIC OIL
After operating for 100 hours, replace the oil in the pump;
•
Discharge the waste oil through the plug (L4) fitted at the
bottom of the pump casing.
•
Clean the seals on the cap and replace it if worn.
•
Clean the filter (L6).
•
Clean and, if necessary, replace the worn seals (L6).
•
Fill the pump with the recommended oil until it reaches the
maximum level the plug (L5).
•
Then, substitute the oil every 250 hours.
www.larius.eu
18
L5
L6
L5
L4
Ediz. 005 - 09/2015
Advertisement
Table of Contents
