Table of Contents
Advertisement
DALì LINER PLUS
•
When the pump idles stop the combustion engine.
•
At this point the machine is ready. If water-based paints are
to be used, after the wash with solvent wash the tank again
with soap and water, then rinse with clean water (repeating
the previously described procedures).
•
Insert the manual gun trigger lock and assemble the nozzle.
PRODUCT PREPARATION
MAKE SURE THE PRODUCT IS SUITABLE TO BE
USED WITH A SPRAY GUN.
•
Mix and filter the product before using it. For filtration
use CLOSE-MESH (rif. 214) and LARGE-MESH (rif. 215)
LARIUS METEX braids.
Make sure the product to be used is compatible
with the materials employed for manufacturing the
equipment (stainless steel and aluminium). Because
of that, please contact the supplier of the product.
Never use products containing halogen hydrocarbons (as methyle-
ne chloride). If these products come into contact with aluminium
parts of the equipment, can provoke dangerous chemical reactions
with risk of explosion.
•
Fill the tank (F20) with the paint.
G
REGULATIONS
ADJUSTING THE GUN POSITION
In order to adjust the position of the spray gun (G1) use the
knobs (G2-G3).
www.larius.eu
14
G1
G3
ADJUSTING THE GUN SUPPORT ARM
In order to adjust the position of the spray gun (G4) use the
knobs (G5).
F20
G2
G5
G4
G4
G5
Ediz. 005 - 09/2015
Advertisement
Table of Contents
