Table of Contents
Advertisement
ADJUSTING BELT TENSION
To adjust the belt tension (G6) you need to follow the following
procedure:
•
Unscrew the 4 screws (G7).
•
Unscrew the locknut (G8).
•
Turn the screw (G9) to make the adjustment.
G6
G7
H
OPERATION
SETUP PROCEDURE
•
Use the tooling after performing all the SETTING UP ope-
rations above described.
•
Check that there is enough unleaded petrol.
•
Open the product output tap (H1).
H1
Ediz. 005 - 09/2015
G7
G8
G7
G9
Turn the equipment knob (H2) on ON (I).
•
•
Start the combustion engine following the indications provi-
ded in the chapter "STARTING COMBUSTION ENGINE".
•
Make sure that the re-circulation/safety valve (H3) is closed
(spray enabled).
•
Turn the pressure (H4) adjustment handle clockwise until
the desired setting has been reached.
H4
DALì LINER PLUS
H2
H3
www.larius.eu
15
Advertisement
Table of Contents
