Table of Contents
Advertisement
4.3
Installation device
Requirements of the installation device
The installation device is designed to ensure that the stator and rotor are aligned centrically
during the entire installation procedure. When installing, observe the effective actual forces.
The installation device must be adapted by the customer in line with the machine
construction. It must be sufficiently rigid so that it is not warped by the strong attractive
forces between the stator and rotor. Radial forces must be taken into account when the
installation device is dimensioned.
The installation device must not have any loose parts.
NOTICE
Destruction of the motor
The stator and rotor must not come into contact with each other during centering and
installation because damage cannot be ruled out.
• Use the installation device during installation.
Example for centering and installing motors
1. Place the stator so that it is centered in the holding fixture of the lower part of the
installation device.
2. Place the rotor so that it is centered in the holding fixture of the upper part of the
installation device.
Naturally cooled 1FW6 built-in torque motors
Operating Instructions, 07/2017, 6SN1197-0AF02-0BP2
Mechanical installation
4.3 Installation device
59
Advertisement
Table of Contents
