® SURF English English Sistemi Elettronici INSTALLATION MANUAL di Apertura Porte e Cancelli International registered trademark n. 804888 CHARACTERISTICS AND SPECIFICATIONS SURF is an irreversible, strong and safe, easy to install electromechanical swing gate operator, for leaf lengths up to max.
Page 3
® SURF English English Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 Fig. 3 67411010 Rev. 10 - 06/2014...
Page 4
® SURF English English Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 STANDARD INSTALLATION Model SURF 230V EXIT ENTRY 1) The Surf unit 2) Mechanical stop Fig. 4 3) Swing 2/Gate 2 electronic control unit 4) Flashing lamp 5) Photocell Dx 6) Differential switch 16A - 0,03A 7) Photocell Sx...
Page 5
® SURF English English Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 GATE ARRANGEMENT You must do some checks on the gate to see if fitting a SURF system is possible: A.(Make sure that) the fixed and moving parts of the gate are strong and non-deformable; B.the length of each gate leaf must not exceed 3,5 m for SURF 350/350 24V/350 Reversible and 2,5 m for SURF 250/250 24V, always respecting the graph;...
Page 6
® SURF English English Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 INSIDE OPENING INSTALLATION Total stroke 400 mm - max. recommended stroke 380 mm Max. Max. Stroke Outside for 90° Opening Stroke (mm) (mm) (mm) (mm) Angle (mm)
Page 7
® SURF English English Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 INSTALLATION ON MASONRY PILLARS, MAKING A NICHE 80 Min. 1078 155 Min. WARNING: During installation, make sure that the cables do not interfere with the niche.
Page 8
® SURF English English Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 NOTE: To avoid the oscillation of the operator during operating phase, it is recommended to adjust the nut (1) being careful not to block the rotation of the operator on the fitting. Nut (1) Fig.
Page 9
® SURF English English Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 Fig. 17 Front fixation Warning: in case of screwed front fixation, the front fixation DOES NOT HAVE TO INCLINE like showed in fig.17 when it reaches the limit stop, otherwise it can cause damages to electronical limit switches. NOTE: When placing the front fixation on the gate, consider the shift in comparison to the central axle of the operator (Fig.18).
Page 10
® SURF English English Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 CONNECTIONS 24V With mechanical and limit switch ATTENTION: The limit switches must be used only for the connection to the control units and n o t d i r e c t l y connected to the electric motor.
NOTE: THE MANUFACTURER CAN NOT BE DEEMED RESPONSIBLE FOR ANY DAMAGE OR INJURY CAUSED BY IMPROPER USE OF THIS PRODUCT. SEA reserves the right to do changes or variations that may be necessary to its products with no obligation to notice. 67411010...
Page 12
® SURF English English Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 To the attention of users and technicians INSIDE RELEASE SYSTEM WITH Push and PLASTIC KEY 90° turn To release operate as follows: Turn counter- clockwise the lock protection door (fig.
Page 13
5) DELIVERY Delivery shall take place, approximately and not peremptorily, within 30 working days from the date of receipt of the order, unless otherwise notified. Transport of the goods sold shall be at Buyer’s cost and risk. SEA shall not bear the costs of delivery giving the goods to the carrier, as chosen either by SEA or by the Buyer. Any loss and/or damage of the goods during transport, are at Buyer’s cost.
Page 14
14. Transit through the leaves is allowed only when the gate is fully open. 15. The User must not attempt to repair or to take direct action on the system and must solely contact qualified SEA personnel or SEA service centers. User can apply only the manual function of emergency.
Page 15
3. Este producto fue diseñado y construido exclusivamente para el uso especificado en esta documentación. Cualquier otro uso no expresamente indicado puede afectar la integridad del producto y ser una fuente de peligro. El uso inadecuado es también causa de anulación de la garantía. SEA S.p.A. se exime de toda responsabilidad causadas por uso inapropiado o diferente de aquel para el que el sistema automatizado fue producido.
Page 16
La SEA S.p.A. dichiara sotto la propria responsabilità e, se applicabile, del suo rappresentante autorizzato che i prodotti: SEA S.p.A. declares under its proper responsability and, if applicable, under the responsability of its authorised representative that the products: Descrizione / Description...
Page 17
® Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 Note - Notes - Note - Notas - Anmerkung...
Page 18
è stato testato singolarmente al fine di garantire i più alti livelli qualitativi e la vostra soddisfazione. Vi ringraziamo per aver scelto SEA. This item has been produced following strict production procedures and has been singularly tested for the highest quality levels and for your complete satisfaction.
Page 19
N.B: L’estensione della garanzia legale di 12 mesi a 24 mesi e 36 mesi è va- lida solo se il presente modulo viene rispedito per posta o fax a SEA S.p.A. entro 15gg dalla data di acquisto. Allegare relativa fattura d’acquisto.
Page 20
® Sistemi Elettronici di Apertura Porte e Cancelli International registered trademark n. 804888 SEA S.p.A. Zona industriale 64020 S.ATTO Teramo (ITALY) Tel. +39.0861.588341 - Fax+39.0861.588344 seacom@seateam.com www.seateam.com...
Need help?
Do you have a question about the SURF Series and is the answer not in the manual?
Questions and answers