Link Types Of Ethernet Ports; Configuring The Default Vlan Id For An Ethernet Port - H3C S3600-28P-SI Operation Manual

Operation Manual – Port Basic Configuration
H3C S3600 Series Ethernet Switches-Release 1510
Model
H3C
S3600-52P
-PWR-EI
H3C
S3600-52P
-PWR-SI

1.1.2 Link Types of Ethernet Ports

An Ethernet port on an S3600 switch can operate in one of the three link types:
Access: An access port can belong to only one VLAN, and is generally used to
connect user PCs.
Trunk: A trunk port can belong to more than one VLAN. It can receive/send
packets from/to multiple VLANs, and is generally used to connect another switch.
Hybrid: A hybrid port can belong to more than one VLAN. It can receive/send
packets from/to multiple VLANs, and can be used to connect either a switch or
user PCs.
Note:
A hybrid port allows the packets of multiple VLANs to be sent without tags, but a trunk
port only allows the packets of the default VLAN to be sent without tags.
You can configure all the three types of ports on the same device. However, note that
you cannot directly switch a port between trunk and hybrid and you must set the port as
access before the switching. For example, to change a trunk port to hybrid, you must
first set it as access and then hybrid.

1.1.3 Configuring the Default VLAN ID for an Ethernet Port

An access port can belong to only one VLAN. Therefore, the VLAN an access port
belongs to is also the default VLAN of the access port. A hybrid/trunk port can belong to
several VLANs, and so a default VLAN ID for the port is required.
After you configure default VLAN IDs for Ethernet ports, the packets passing through
the ports are processed in different ways depending on different situations. See Table
1-2 for details.
Number of
Number of 100
service
Mbps ports
ports
48 10/100 Mbps
52
(electrical)
48 10/100 Mbps
52
(electrical)
1-2
Chapter 1 Port Basic Configuration
Number of
1000 Mbps
Console port
uplink ports
4 (SFP) 1
4 (SFP) 1