Table of Contents
Advertisement
Section 4
Figure 12
Battery Pack Compartment
1
2
1.
Loosen to remove batteries (after removing the battey pack).
2.
Loosen to remove the battery pack from the meter.
3.
Remove power cable.
4.1.4 Battery-Life Estimates
Page 32
Battery Information
5. Remove the old batteries. Install the fresh batteries into the battery pack
compartment, terminal-end first. It does not matter which way the
battery is rotated when it is inserted. The battery holder will accept the
batteries regardless of polarity.
6. Replace the retainer plate and tighten the fasteners by hand until they are
secure. This applies the proper compression to the battery terminals. Use
care not to over-tighten the fasteners.
7. Reattach the power cable to the flow meter in the bottom of the battery
compartment. The cable is keyed and will only fit in the proper orientation.
8. Insert the battery pack into the battery compartment and tighten the two
captive fasteners.
9. Replace the instrument cap.
Eveready Energizer
EN 529 Alkaline
When using Energizer EN-529, alkaline, 6 V dc batteries, battery life is
based on:
•
Number of sensors installed
•
Recording intervals (longer intervals increase battery life)
•
Number of channels logged in memory
Eveready Energizer
EN 529 Alkaline
3
MeterInstallation.fm
Advertisement
Table of Contents
