Weight; Connectors; Scsi Cables And Terminators - Sony DDS-4 Product Description Manual

2. SPECIFICATION

2. 1. 2 Weight

• SDT-10000/SDT-11000 - 600 grams (1 lb 5 oz), without a cassette

2. 1. 3 Connectors

The SDT-10000/SDT-11000 has a SCSI connector with a power connector at the positions shown in Figure 2-3. All
other connectors are for use by Sony's manufacturing and service facilities only.

2. 1. 3. 1 SCSI Cables and Terminators

The Single-Ended SCSI configuration is supported by SDT-10000 and SDT-11000.
The Low-Voltage-Differential SCSI configuration is supported by SDT-11000. The hardware specification of this inter-
face can be found in Clause 3. Physical Characteristics, of the X3T10/1142D (SCSI Parallel Interface2) standard. Only
unshielded connectors are supported. Possible cable and connector sources are listed below. This does not imply that
these are the only sources for SCSI accessories.
Note: When using high speed data transfer with the SDT-10000/SDT-11000, it is recommended that total length of the
SCSI data cable not exceeded 1.5m for Single Ended SCSI configuration. As for Low-Voltage-differential SCSI
configuration for SDT-11000, less than 12m is recommended.
Cable
Connector
SCSI & Power Connector
SDT-10000/SDT-11000
Figure 2-3 Connector Positions
30 AWG Ribbon
Hitachi UL 20818 (or equivalent)
AMP 1-786090-7 (or equivalent)
SONY SDT-10000/SDT-11000 DDS Tape Drive 2 - 3