Table of Contents
Advertisement
2.Specification
Weight
2.1.2.
SDX-900V
SDX-900V/R
Connectors
2.1.3.
The SDX-900V has a SCSI connector with a power connector and Jumpers at the positions shown in Figure 2-3. All
other connectors are for use by Sony's manufacturing and service facilities only.
The Single-Ended SCSI configuration and Low-Voltage-differential SCSI configuration are supported by SDX-900V,
and SDX-900V/R The hardware specification of this interface can be found in Clause 3. Physical Characteristics, of
the X3T10/1142D (SCSI Parallel Interface2) standard. Only unshielded connectors are supported. Possible cable
and connector sources are listed below. This does not imply that these are the only sources for SCSI accessories.
Note: When using high speed data transfer with the SDX-900V it is recommended that total length of the SCSI data
cable not exceeded 1.5m for Single Ended SCSI configuration. As for Low-Voltage-differential SCSI configuration,
less than 12m is recommended.
Cable
Connector
2.2. Environmental Specifications
The specifications which apply when media is present may be different than these.
Temperature and Humidity Range
2.2.1.
Temperature
Operating
Non-Operating(mech.)
Non-Operating(tape)
Humidity
Operating
Non-operating (mech.)
Non-operating (tape)
.
2-4
780 grams, without a cassette and a front bezel.
1010 grams, without a cassette and a front bezel.
SCSI 68 pin Connector
Figure 2-3: Connector Positions
SCSI Cables and Terminators
2.1.3.1.
30 AWG Ribbon
Hitachi UL 20848 (or equivalent)
AMP 1-786090-7 (or equivalent)
5 ºC to 40 ºC (ΔT < 10 ºC/h)
-40 ºC to 70 ºC (ΔT < 20 ºC/h)
-40 ºC to 45 ºC (ΔT < 20 ºC/h)
20 to 80% RH, non-condensing
Maximum wet bulb temperature = 26 ºC
5 to 95%RH(ΔRH<30%/h)
Maximum wet bulb temperature = 45 ºC
20 to 80%RH(ΔRH<30%/h)
Jumpers
Power Connector
SONY AIT-4 drive SDX-900V series Ver.2.1
Advertisement
Table of Contents
