Using A Microphone; Adjusting The Sound Quality - PIONEER DJ DDJ-1000SRT Operating Instructions Manual

• Turn clockwise: Gradually increases the high-pass filter's cut-off
frequency.

Using a microphone

1 Connect a microphone to the [MIC1] input terminal or [MIC2] input
terminal.
2 Set the [OFF, ON, TALK OVER] switch to [ON] or [TALK OVER].
– [ON]: The indicator lights up.
– [TALK OVER]: The indicator flashes.
• When you set the switch to [TALK OVER], the sound of channels other than
the [MIC1] channel and [MIC2] channel is attenuated by -18 dB (default)
when a sound of -10 dB or greater is input to the microphone.
• The level of attenuation applied when you set the switch to [TALK OVER]
can be changed in Utilities mode. For details on how to change this setting,
read: MIC TALKOVER level setting (page 99).
• Talkover mode can be switched between Normal mode and Advanced mode.
For details on how to change this setting, read: MIC TALKOVER mode
setting (page 99).
3 Turn the [MIC1 LEVEL] knob or [MIC2 LEVEL] knob.
Adjust the volume of the sound output from the [MIC1] channel or [MIC2]
channel.
• The sound comes out at a loud volume if the knob is turned all the way to the
right.
4 Input audio to the microphone.

Adjusting the sound quality

Turn the [EQ (HI, LOW)] knobs.
– [HI]: –12 dB to +12 dB (10 kHz)
– [LOW]: –12 dB to +12 dB (100 Hz)
Advanced use
91
En