PIONEER DJ DDJ-1000SRT Operating Instructions Manual page 77

5 Selected channel
Displays the channel to which the effect is to be applied. Displays [SP]
(Sampler), [MIC], [CH 1], [CH 2], [CH 3], [CH 4], or [MST] (Master) according
to the selected channel.
1 Press the [BEAT ] button or [BEAT ] button while holding the
[SHIFT] button.
Select the BPM measurement mode.
– [AUTO]: Press the [BEAT ] button while holding the [SHIFT] button. The
BPM is automatically measured from the input audio signal.
– [TAP]: Press the [BEAT ] button while holding the [SHIFT] button. Enter
the BPM manually. For details, read: Inputting the BPM manually (page 78).
• The BPM measurement range for the [AUTO] setting is 70 to 180. BPM may
not be correctly measured for some tracks. If the BPM can't be measured,
the BPM value on the display flashes. In such cases, use the [TAP] button
to input the BPM manually.
2 Rotate the [BEAT FX SELECT] knob.
Selects a type of effect.
• For details, see: Types of BEAT FX (page 79).
3 Rotate the [BEAT FX CH SELECT] knob.
Selects a channel to apply the effect to.
• Set [Sampler Player Output Select] to [A] on Serato DJ Pro.
– [SP]: Applies the effect to the sound of [SAMPLER].
– [MIC]: Applies the effect to the sound of the [MIC] channel.
– [1] to [4]:Applies the effect to the sound of the respective channel.
– [MST]: Applies the effect to the sound of the [MASTER] channel.
4 Press the [BEAT ] button or [BEAT ] button.
Increases or decreases the effect timing.
The effect time corresponding to the selected length is set automatically.
Advanced use
77
En