Danfoss m2 Manual page 33

Choice of measurements to be displayed as pri-
mary and secondary:
Select the menu: Setup Menu \ Point Setup
Number: Select the point number (i.e. address
number of EKC)
Type: Select "EKC"
Alarms: Will always be "Remote". The alarm limits
for the controller will be used.
Other settings are those normally used for m.
m Version 3.11
Next menu
Press and hold down the 'Enter' key until the second Point Setup screen is
displayed or press the ' ' in the point type field.
Input Source:
Primary Temp: Used to select the parameter to be displayed
Secndary Temp: Used to select the parameter to be displayed
Other settings are those normally used for m.
Manual RS.8A.N5.0 © Danfoss 10-007
Select "ECHELON" (= data communication)
as primary
as secondary
33