Alarm Action Setup; Output Name; Action N - Danfoss m2 Manual

Alarm Action Setup

Output Name

Action n


The sample frequency affects the amount of data that will be stored in the units
memory.
Example table for days using 40 points.
Example table for frequency using 40 points.
These calculations can alter if a large amount of alarms are stored.
Use this option to define the action to take place when an alarm occurs. From
the Setup Menu, select the Alarm Action Setup option.
Use the '
each device as described below.
Type in up to 8 characters as an appropriate name for the output device. Use '
' or '
the cursor left or right respectively.
You can use the ' ' and ' ' keys together to delete the character before the
cursor and '
Use this field to specify when the device is to be used. Set the trigger as follows
for each of the Alarm Actions:
Manual RS.8A.N5.0 © Danfoss 10-007
TDays = Total number of days stored in memory
Freq = Graph sample frequency
Pt = Highest point number used
Total = Total memory available
TDays = Freq x (Total - 464000)
1440 x (6+(2 x Pt))
Freq = 1440 x TDays x (( x Pt)+6)
Total - 464000
Freq Days
1 47
 94
5 35
10 471
15 706
Days Freq (in minutes)
100 
00 4
300 6
500 11
700 15
' or ' ' keys to cycle through the devices and complete the fields for
RELAY 1 MODEM 
RELAY  MODEM 3
SIREN MODEM 4
LAMP MODEM 5
FLASH PRINT
MODEM 1
' keys to cycle through the character list and the ' ' or ' ' key to move
' to change case. Press '↵' to move onto the next field.
0 Always OFF (Never trigger)
1 Always ON (day and night) (Always trigger)
D ON during the day (Trigger during the day only)
N ON during the night (Trigger during the night only)
- Mb = 09715
- 4Mb = 4194304
- 6Mb = 691456
- 8Mb = 8388608
m Version 3.11