Setting Temperature Units; Setting Date Format; Name; Setting The Point Type - Danfoss m2 Manual

Setting Temperature Units

Setting Date Format

Setting the Point Details
Selecting a Point Number

Name

Setting the Point Type

16
Enter the installation name using the '
character list and the ' ' or ' ' key to move the cursor left or right respectively.
You can use the ' ' and ' ' keys together to delete the character before the
cursor. When the installation name is complete, press '↵' , then '
to the Setup Menu. Next time you display the Point Overview screen the
installation name will appear at the top of the screen.
The m's temperature unit of measurement can be set to either fahrenheit or
centigrade. To select the temperature unit, press the '↵' key to move the active
field box around the 'temperature units' field, then use the '
toggle between fahrenheit and centigrade.
The date format of the m unit can be set to either 'DD/MM' or 'MM/DD' . To
select the date format required, press the '↵' key to move the active field box
around the 'temperature units' field, then use the '
between 'DD/MM' and 'MM/DD' .
To set up the details of an individual point, select the Point Setup option from
the Setup Menu. The Point Setup screen is displayed with the point number
displayed in the top left hand field.
To select a different point number, use the '
selected, the settings for the selected point are displayed.
To set the name of an individual point, ensure that the cursor is on the correct
point number and press '↵' . The cursor will move to the Name field. Enter the
installation name using the '
and the ' ' or ' ' key to move the cursor left or right respectively. A maximum
of 18 characters can be entered into this field.
You can use the ' ' and ' ' keys together to delete the character before the
cursor and '
'↵' . The edit box will move onto the next field.
To set the point type, repeatedly press '↵' to cycle through the fields until the
Type field is highlighted. The input type code refers to the input connected to
that point. This can be altered by using the '
list of available types, which are defined as follows.
Off
RTD
PT1
PT2
PT3
EKS
Low
Eno
Enc
Dno
Dnc
420
Cf1
Cf2
Cf3
Cf4
Manual RS.8A.N5.0 © Danfoss 10-007
'or '
' to change case. When the installation name is complete, press
No input connected
PT1000 temperature probe (-100 to +100°C)
Low temp. thermistor probe (-80 to 0°C)
Standard thermistor probe (-40 to +40°C)
High temp. thermistor probe (0 to +100°C)
EKS111 probe (-35 to +85°)
PT1000 Version Only
Not applicable
Equipment (normally-open)
Equipment (normally-closed)
Defrost interlock (normally-open)
Defrost interlock (normally-closed)
4-0 mA input*
Programmable curve No.1 - input is cross-referenced
to a table held in memory.
Programmable curve No. - input is cross-referenced
to a table held in memory.
Programmable curve No.3 - input is cross-referenced
to a table held in memory.
Programmable curve No.4 - input is cross-referenced
to a table held in memory.
' or ' ' keys to cycle through the
' or '
' or ' ' key to toggle
' or ' ' key. As each number is
' keys to cycle through the character list
' or ' ' keys to scroll through the
PT1000 Version Only
Thermistor Version Only
Thermistor Version Only
Thermistor Version Only
m Version 3.11
' to return
' key to