Software Version; Setting The System Time And Date - Danfoss m2 Manual

Software Version

Setting the System Time and Date

m Version 3.11
The various codes printed in the status (St) column are defined as follows:
ok
Alm
dEF
dEP
dFP
E
Err
Flt
Hi
Inh
Low
Off
OVR
OC
SC
The various codes displayed in the printout Reason column are defined as
follows:
Aft.Def
Fault
>
<
Use this option to display the units software and hardware details for reference.
To return to the Main Menu, either wait 1 minute or press any key.
To set the system time and date, select the Time / Date option from the Main
Menu. The Password request is displayed. Enter your User passcode (the
default passcode is WOODLEY or the Local passcode).
Use '
the ' ' or ' ' key to move the cursor left or right respectively. Then press '↵' to
move onto the next field.
The system time and date are read from the internal clock. If these are incorrect
amend them as appropriate.
The Start Day and End Day settings are used to indicate the start and end of
trading. This allows the system to perform different operations depending on
the time of day.
For example, the system could be set up so that during the day only an audible
alarm is activated, whereas the system would dial-out at night.
Select each of the days in turn and type in or amend the times as required.
·
·
·
The Special Days are used to override the normal weekday start and end times.
Note: The Special Days will occur every year if they are not changed.
Manual RS.8A.N5.0 © Danfoss 10-007
No fault present
Equipment fault
Defrost
Defrost pulldown - (only shown on display)
Defrost pulldown - (only shown on printouts)
Equipment (status ok)
Equipment (status alarm)
Comms fault
High alarm
Inhibit
Low alarm
The input is off
Defrost overrun alarm
Signal over range
Signal under range
Alarm after defrost
probe fault
High value alarm greater than high alarm limit
Low value alarm less than low alarm limit.
' or ' ' keys to cycle through the character list to the required value and
Use the ' ' or ' ' keys to cycle through the day of the
week and the special days.
Set the Start and End day values.
Set the date of any Special Days (dd/mm) (5 Special
Days maximum).
13