Table of Contents
Advertisement
INSTALLATION
CT2X INSTRUCTIONS
Connecting to Sensors
Aqua4Plus 2.0 is designed to automatically detect your communication cable and scan for sensors. It is recommended
you connect your USB/RS485 cable to your PC and have the sensor connected before opening Aqua4Plus 2.0.
If your cable and sensor were not connected before opening Aqua4Plus 2.0 simply connect and click Rescan. While
scanning is active you'll see a green dot flash in the upper right corner of the program. Scanning is complete when this
dot stops flashing.
If your sensor still won't connect you can expand the Modbus address range under program settings here:
Simply drag the Address Range slider higher up to increase the maximum Modbus address scanned. If you've scanned
all the way up through address 255 and still have no connection click Troubleshooting for further troubleshooting or
contact Seametrics Tech Support for assistance.
Click
at any time to refresh sensor information.
Seametrics • 253.872.0284
Page 8
seametrics.com
Advertisement
Table of Contents
Need help?
Do you have a question about the CT2X and is the answer not in the manual?
Questions and answers