Sleep - GE MDS RCL220 Manual

RCL220_manual_v3-draft.doc
LASTMFREQ3=<XXX.XXXXXX> Committed channel 3 M(Mobile) Frequency
Acceptable value range: 216-222 MHz Channels
LASTBFREQ4=<XXX.XXXXXX> Committed channel 4 B(Repeater) Frequency
Acceptable value range: 216-222 MHz Channels
LASTMFREQ4=<XXX.XXXXXX> Committed channel 3 M(Mobile) Frequency
Acceptable value range: 216-222 MHz Channels
CMD=<cmd> If set to 0, the command executes normally. If <cmd> is set to 1, the
command reports all settings in a format that may be copied into a configuration
script.
3.2.18

SLEEP

Usage: SLEEP {MODE=<mode>} {WAKE=<wake>} {DTRSENSE=<dtrsense>}
{HANGTIME=<hangtime>} {NOW=<now>} {CMD=<cmd>}
Description: Set / display the configuration of the radio's low power mode.
NOTE: CMD=1 short form response command is supported.
Access Level: Administrator
Optional Arguments:
MODE=<mode> Write Only for all users, starting at Administrator. This selects one
of the low power operating modes the remote will operate under.
NONE
SLEEP
SHUTDOWN
WAKE=<wake> Write Only for all users, starting at Administrator. This selects a
control option to activate(enter) or deactivate(exit) sleep or shutdown modes.
DTR
DATA
DTRSENSE=<dtrsense> Write Only for all users, starting at Administrator. DTR
sense setting.
LOW
05-XXXXA01 Version 3 Draft
Normal mode
Sleep enabled
Shutdown enabled
Wake under DTR signal control
Wake up on data
DTR Active LOW
Page 45 of 79 9/20/2016