GE MDS RCL220 Manual page 31

RCL220_manual_v3-draft.doc
Length: 1-16 characters
PRODUCT=<product> Read only for all users listed above.
ENTRANET
TYPE=<type> Read only for all users listed above.
REMOTE
AP
COM2=<com2> Read Only for all users listed above. com2 type
RS232
RS4XX
ETHERNET=<ethernet> Read Only for all users listed above.
DISABLED
ENABLED
MANAGEMENT=<management> Read Only for all users listed above.
DISABLED
ENABLED
SERIAL=<serial > Read Only for all users listed above.
DISABLED
ENABLED
DONT_CARE=<dont_care > Read Only for all users listed above.
0
1
RUN=<run> Read Only for all users listed above. Allowed to Run
DISABLED
ENABLED
ENDPOINTS=<endpoints> Read Only for all users listed above.
SINGLE
MULTIPLE
05-XXXXA01 Version 3 Draft
entraNET
Remote
Access Point
COM2 supports RS232
COM2 supports RS485
Ethernet disabled
Ethernet enabled
Network management disabled
Network management enabled
Serial payload disabled
Serial payload enabled
X: don't care
X: don't care
Firmware disabled
Firmware enabled
Single ethernet endpoint
Multiple ethernet endpoints
Page 31 of 79 9/20/2016