Power Connector Pinout; Entranet 220 Oem Radio Module - GE MDS RCL220 Manual

RCL220_manual_v3-draft.doc
13 12 11 10 9 8
25 24 23 22 21

2.1.3 Power Connector Pinout

The Access Point provides a Phoenix 17 76 69 2 connector for DC power in. A surge protection device
such as a Polyphaser IS-17VDC-30A-NG capable of limiting the voltage input to the radio to less than
30 Volts should be employed.
Pin Signal Name
1 (L) PWR
2 I GROUND

2.2 entraNET 220 OEM Radio Module

This unit is used in each OCU. It is a two-board solution (as shown below) that mates with RCL vendor
OCU hardware. Mechanical diagrams are provided below as well. The interfaces used by OEM Radio
Modules are listed in the tables below.
Figure 10 entraNET 220 OEM Radio Module (SMB Connector Not Shown)
05-XXXXA01 Version 3 Draft
7 6 5 4 3 2
20 19 18 17 16 15
Direction with respect to MDS Equipment
Input
Input
Page 10 of 79
1
14
Description
10 to 30 VDC input,
125 mA at 13.8 VDC
Power return.
9/20/2016