Config; Device - GE MDS RCL220 Manual

RCL220_manual_v3-draft.doc
7E2
8N1
8N2
8O1
8O2
8E1
8E2
LEVELS=<levels> Read / Write. Set / display interface choice. Valid choice must
be authorized by factory.
RS232
RS485
DUPLEX=<duplex >
FULL
HALF
CMD=<cmd> If set to 0, the command executes normally. If <cmd> is set to 1, the
command reports all settings in a format that may be copied into a configuration
script.

3.2.5 CONFIG

Usage: CONFIG {SHOW} {SAVE=}
Description: Save/Display the current configuration. The output is in a format that
may be copied back into the command line in order to set the configuration.
NOTE: CMD=1 command not supported.
Access Level: Administrator
Optional Arguments:
SHOW Read Only for all users listed above. Display the current configuration.
SAVE= Read Only. Save the current configuration
FACT

3.2.6 DEVICE

Usage: DEVICE {COMPANY=} {MODEL=} {PRODUCT=} {REV=} {OWNER=<owner>}
{TYPE=<type>} {UPTIME=} {SER=} {OEM=<oem>} {CMD=<cmd>}
05-XXXXA01 Version 3 Draft
7 char bits, even parity, 2 stop bits
8 char bits, no parity, 1 stop bit
8 char bits, no parity, 2 stop bits
8 char bits, odd parity, 1 stop bit
8 char bits, odd parity, 2 stop bits
8 char bits, even parity, 1 stop bit
8 char bits, even parity, 2 stop bits
COM2 supports RS232
COM2 supports RS485
Full-Duplex
Half-Duplex
Save current config to factory config
Page 35 of 79 9/20/2016