gledhill BoilerMate A-Class OV SOL Series Design, Installation & Servicing Instructions page 10

DESIGN
Connection Details/Dimensions - 265 model
Connection Details/Dimensions - 285 model
640
710
Page 10
Connection Details/Dimensions
Diagrams opposite show the connection details
and dimensions for the BoilerMate A-Class OV
SOL appliance.
The BoilerMate A-Class OV SOL units are supplied
on an installation base to allow the pipe runs
to connect to the appliance from any direction.
It is easier if all pipes protrude vertically in the
cut out area shown. Compression or push fit
connections can be used. All pipe positions
are approximate and subject to a tolerance of
+/-20mm in any direction. A 15mm cold water
supply and a 22mm warning/overflow pipe
will also be required for the separate feed and
expansion tank.
Note: All dimensions will be updated in the
next issue of the manual.
Figure 1.7
Figure 1.8