Table of Contents
Advertisement
INSTALLATION
Before You Begin
Always disconnect the negative battery terminal
Important Notes
•
Before final installation, test the wiring connections to make sure the unit is
connected properly and the system works.
•
Consult with your nearest dealer if installation requires the drilling of holes or
other modifications to your vessel.
•
Install the unit where it does not interfere with operating the vessel and
cannot injure passengers.
•
Use the included template to cut the installation opening.
Commander Cover
•
During storage, use the included cover to prolong the life of your device by
protecting the wired commander from direct sunlight, moisture, dust, and
other elements.
Wired Commander Mounting
•
Choose a mounting area for the wired commander that is clean and flat,
allowing the rear gasket to fully seal to the mounting surface.
•
Secure the wired commander using either of the recommended mounting
methods detailed below.
Bracket Mount
•
Insert wired commander through cut-out and secure with bracket using
included hardware as detailed in the diagram.
Screw Mount
•
Secure the wired commander to the mounting surface using #6 stainless
steel pan head screws (not included) as detailed in the diagram.
Bracket Mount
Mounting
Bolt
Washer
Commander
Screw Mount
Mounting Screws
Trim Bezel
5
UM2
Lock nuts
Mounting Bracket
Commander
Advertisement
Table of Contents
