Installation; Important Notes - Polk Mono UM1 Installation And Operation Manual

INSTALLATION

Before You Begin
Always disconnect the negative battery terminal

Important Notes


Before final installation, test the wiring connections to make sure the unit is connected
properly and the system works.

Consult with your nearest dealer if installation requires the drilling of holes or other
modifications to your vessel.

Install the unit where it does not interfere with operating the vessel and cannot injure
passengers.

Use the included template to cut the installation opening.
Commander Cover

During storage, use the included cover to prolong the life of your device by protecting
the wired commander from direct sunlight, moisture, dust, and other elements.
Wired Commander Mounting

Choose a mounting area for the wired commander that is clean and flat, allowing the
rear gasket to fully seal to the mounting surface.

Secure the wired commander using either of the recommended mounting methods
detailed below.
Bracket Mount

Insert wired commander through cut-out and secure with bracket using included
hardware as detailed in the diagram.
Screw Mount

Secure the wired commander to the mounting surface using #6 stainless steel pan
head screws (not included) as detailed in the diagram.
Bracket Mount
Screw Mount
4
UM1