Table of Contents
Advertisement
Setting the User Passcode
Press and hold the Menu button (9) for more than 3 seconds to enter the
1.
system menu.
Rotate the Encoder Knob (5) to navigate the menu list to the "SiriusXM
2.
Setup" option.
Press the Encoder Knob button to view "Set Lock Code...".
3.
Press the Encoder Knob button to select Set Lock Code. "Enter Lock Code:
4.
0 _ _ _" prompt message will appear.
Rotate the Encoder Knob to select a digit (0 – 9) for each number position.
5.
The default code is "0000". Press the Encoder Knob button to confirm
each digit and move to the next digit.
Upon entering the last digit, the unit will prompt for confirmation of the code.
6.
Repeat the same steps to enter the code again.
7.
Locking a Channel
Press and hold the Menu button (9) for more than 3 seconds to enter the
1.
system menu.
Rotate the Encoder Knob to navigate the menu list to the "SiriusXM Setup"
2.
option.
Rotate the Encoder Knob to "Locked Channels...".
3.
Press the Encoder Knob button to select. "Enter Lock Code: 0 _ _ _" prompt
4.
message will appear.
Enter the Lock Code, a list of channels with open lock icons will appear.
5.
Rotate the Encoder Knob to select a channel you wish to lock
6.
Press the Encoder Knob button to lock the channel. The locked icon will
7.
indicate the channel has been successfully locked.
Accessing a Locked Channel
Tune to the desired channel using the |<< or >>| soft buttons or use the
1.
direct access tuning method.
An "Enter Lock Code: 0 _ _ _" prompt message will appear.
2.
Enter the Lock Code within 10 seconds to unlock and tune the channel.
3.
The device will remain in "unrestricted" (unlocked) mode until the next power
4.
cycle.
Reset SiriusXM Channel Lock Code
If you forget your Parental Control lock code, use the following directions to reset
the code to the default "0000". Resetting the lock code will not affect the locked
channels list.
In SiriusXM mode, tune to Channel 0 (Radio ID).
1.
Rotate the Encoder Knob to set the volume to 0.
2.
Press and hold the Setting button to enter the System Setting Menu.
3.
Rotate the Encoder Knob to view the "Firmware".
4.
Press the Encoder Knob once to check the firmware version.
5.
Press the Encoder Knob again to confirm.
6.
Press Return button to exit the system menu.
7.
Press the Power button (1) to turn off and then on the unit. The lock code
8.
has now been reset to "0000"
INFO
Alternate Display Information
Info option is available in Tune, Category and Preset List modes. Press Info soft
button to change the display information in the following order:
Name (Artist) > Song (Title) > Info (Content, if available) > Category (Category) >
Name (Artist).
Satellite Signal Strength
The display will indicate satellite reception strength as shown below.
Signal Strength
No Signal
Weak
Good
Excellent
15
UM2
Strength Display
Advertisement
Table of Contents
