Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Polk Mono UM1
Summary of Contents for Polk Mono UM1
- Page 1 Installation and Operation Manual...
-
Page 2: Table Of Contents
CONTENTS Warnings and Compliance ....................1 Copyrights and Trademarks Introduction ......................... 2 Sirius, XM and all related marks and logos are trademarks of Sirius XM Radio Inc. All rights Safety Information ....................... 3 reserved. Installation .......................... 4 “Made for iPod” and “Made for iPhone” mean that an electronic accessory has been Wiring .......................... -
Page 3: Warnings And Compliance
WARNINGS AND COMPLIANCE WARNING! To reduce the risk of fire of electric shock, do not expose this apparatus to rain or moisture. WARNING! The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on apparatus. FCC Notes WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. -
Page 4: Introduction
INTRODUCTION HARDWARE KIT CONTENTS Mounting System Features Screws x 4 Features of the Polk UM1 marine audio system include: Bolt x 2 Full Dot Matrix LCD AM/FM US/EURO Tuner with 30 Presents (12 AM, 18 FM) SiriusXM-Ready™... -
Page 5: Safety Information
SAFETY INFORMATION When Boating Keep the volume level low enough to be aware of your surroundings. Protect from Water Do not submerge the product in water, as this can cause electric shorts, fire or other damage. Protect from the Elements Use the included cover to protect the wired commander from sunlight, dust, and water while not in use. -
Page 6: Installation
INSTALLATION Bracket Mount Before You Begin Always disconnect the negative battery terminal Important Notes Before final installation, test the wiring connections to make sure the unit is connected properly and the system works. Consult with your nearest dealer if installation requires the drilling of holes or other modifications to your vessel. -
Page 7: Removing The Unit
Removing the Unit Route the tuner/amplifier harness and cable throughout the vessel as required. Keep some slack in the harness/cables so it won't be too tight, as this can cause damage to To remove the commander, remove bracket mount or remove trim ring and mounting screws, the wires. -
Page 8: Wiring
WIRING DESCRIPTION DESCRIPTION SPEAKER RR– SWITCHED +12VDC SPEAKER RR+ GROUND SPEAKER FL+ ILL-DIM (RUNNING LIGHTS) SPEAKER FL– REMOTE TRIGGER SPEAKER FR+ SPEAKER RL+ SPEAKER FR– SPEAKER RL– PIN NO. WIRE COLOR DESCRIPTION +12VDC BLUE DATA WHITE LEFT AUDIO OUT YELLOW RIGHT AUDIO OUT EMPTY NO CONNECTION... -
Page 9: Remote Control Options
SYSTEM DIAGRAM Remote Control Options The JDAB interface supports up to • 1 UM1 Commander • 3 Remote Controls (PRC100BC, PRC200BC, OEM)* • 4 Extension Cables (PRCEC18)* Zone Control Options • 1 UMZC4 Zone Control Extension Module (UMZC4)* Use of additional or unapproved devices may result in unexpected operation. -
Page 10: Basic Operation
BASIC OPERATION Knob to make selection. Rotate the Encoder Knob clockwise to increase and counter-clockwise to decrease. The unit will automatically exit the audio menu after 10 seconds of inactivity. The following menu items can be adjusted. Bass Level Use the Encoder Knob to adjust the Bass level range from “-6” to “+6”. Mid-Level Use the Encoder Knob to adjust the Mid-level range from “-6”... -
Page 11: Auxiliary Input
System Menu NOTE: BT Pair and BT Device menu options are only available while UM1 is in Bluetooth mode. Press and hold the MENU button for more than 3 seconds to enter the system menu. Battery Alarm Operation “SYSTEM MENU” will appear on the display. - Page 12 Liquid Crystal Display (LCD) The current frequency and activated functions are shown on the LCD panel (10). NOTE: LCD panels may take longer to respond when subjected to cold temperatures for an extended period of time. In addition, the visibility of the numbers on the LCD may decrease slightly.
-
Page 13: Tuner Operation
TUNER OPERATION Press the PS soft button to scan stations stored in the current band list. The unit will pause for ten seconds at each preset station. Press PS again to stop scanning when the desired station is reached. LIST Press the LIST soft button to display the preset list. - Page 14 Stereo (ST) The unit will automatically pick up an FM stereo signal, when available. When in stereo mode, the “ST” icon appears in the display. When no stereo signal is available, the unit will automatically revert to mono operation, and no icon will be displayed.
-
Page 15: Weather Band Operation
WEATHER BAND OPERATION What is the NOAA Weather Radio/Weatheradio Canada? Weatherband Frequencies NOAA (National Oceanic and Atmospheric Administration) is a nationwide system that Frequency (MHz) Preset broadcasts local weather emergency information 24 hours a day via the National Weather 162.400 Service (NWS) network. -
Page 16: Siriusxm ® Radio Operation
SiriusXM RADIO OPERATION ® Rotate the Encoder Knob to select each digit. Press the Encoder Knob button for each digit to enter “000”. ® NOTE: Only SiriusXM brings you more of what you love to listen to, all in one place. Upon entering the last digit, the unit will tune to the SiriusXM ID number for your tuner. - Page 17 locking channels and the method to access locked channels is described below. Press the PS soft button to scan stations stored in the preset list. The unit will pause for ten Setting the User Passcode seconds at each preset channel. Press the Encoder Knob button or the PS soft button Press and hold the MENU button for more than 3 seconds to enter the system menu.
- Page 18 With the unit turned off, press and hold the Power Button until the system version information is displayed on the screen. Press the Encoder Knob button to turn the LCD display off. Press the Power Button to turn on the unit. The lock code has now been reset to “0000”.
- Page 19 Advisory Messages Reported by the SiriusXM Vehicle Tuner On-Screen Display Advisory Message Cause Explanation/Solution Check Antenna Check Antenna The radio has detected a fault with the SiriusXM antenna. The Verify that the antenna cable is connected to the SiriusXM Tuner. ...
- Page 20 Advisory Messages Reported by the SiriusXM Vehicle Tuner (Continued) On-Screen Display Advisory Message Cause Explanation/Solution Chan Locked Channel Locked The channel that you have requested is Locked by the radio Parental See the section on Parental Control, page 15 for more information on Control feature.
-
Page 21: Usb Mp3 Operation
USB MP3 OPERATION NOTE: After loading a USB device, files and folders are accessed in the order in which they were written to the device. Therefore, the playing order may not be the same as the order in which they are expected to be played. Accessing USB Mode Switching to USB Mode Press the MODE button (7) twice to enter mode selection display. -
Page 22: Ipod ® Operation
To enter iPod mode from any other source, press the MODE button (7) and select the USB iPod OPERATION ® soft key. If the user connects an iPod containing no songs, the radio will display a message stating “No Songs” when it enters iPod mode. Controlling Playback This unit is equipped with an iPod ready function that will allow you to control your iPod (if compatible) using the control panel buttons. -
Page 23: Bluetooth Operation
Before you begin, consult the owner’s manual for the Bluetooth device you want to pair with the UM1. Make sure the device is on and ready to receive a signal from the UM1. There are two methods to pair a device; through the user menu or press and hold the Encoder Knob while unit is in BT mode. - Page 24 BT Audio (A2DP) When connected, a Bluetooth enabled device is able to stream audio to the UM1. To access Bluetooth mode and play songs stored on your phone, press the MODE button (7). While in BT mode, the BT AUDIO icon illuminates on the LCD.
-
Page 25: Specifications
SPECIFICATIONS TROUBLESHOOTING FM Radio Frequency Coverage (USA) ........87.5 to 107.9 MHz Symptom Cause Solution... - Page 26 www.asaelectronics.com v.062514...