Basic Operation - Polk Mono UM2 Installation And Operation Manual

BASIC OPERATION

Power On/Off
Press the Power button (1) to turn the unit on/off.
Volume
To increase the volume, rotate the Encoder Knob (5) clockwise. To decrease the
volume, rotate the Encoder Knob counter-clockwise.
Play/Pause/Mute
Press the ►|| button (4) on the control panel to pause or mute the audio output.
Press ►|| button again to unmute or resume the audio.
Mode
Press the Mode button (6) on the control panel to enter mode selection display.
Continue to press the Mode button to page through the available playback modes.
Press the associated soft button for the desired playback mode as displayed.
Audio Menu
Press the Menu button (9) on the control panel to access the audio menu. You can
navigate through the audio menu items by rotation the Encoder Knob and
pressing the Encoder Knob to make selection. Rotate the Encoder Knob
clockwise to increase and counter-clockwise to decrease. The unit will
automatically exit the audio menu after 10 seconds of inactivity. The following
menu items can be adjusted.
Bass Level
Use the Encoder Knob to adjust the Bass level range from "-6" to "+6".
Treble Level
Use the Encoder Knob to adjust the Treble level range from "-6" to "+6".
Balance
Use the Encoder Knob to adjust the Balance between the left and right speakers
from "L12" (full left) to "R12" (full right).
Fade
Use the Encoder Knob to adjust the Fader between the rear and front speakers
from "R12" (full rear) to "F12" (full front).
Sub
Use the Encoder Knob to adjust the Sub level range from 0 to 40.
Equalizer
When Zone is turned off, press the EQ soft button to turn on the equalization
function and select between five pre-defined bass and treble curves: User > Flat >
Rock > Classical > Pop.
Loudness
Press the Loud soft button to toggle loudness on/off. When listening to music at
low volumes, this feature will boost the bass and treble ranges.
Zones
The unit connects to UM2DSP using JDAB 4PIN. When Zone Toggle is On, Zone
Settings and SUB volume are adjustable (default at 20). Press the Menu button (9)
on the control panel to access the audio menu, and then press the soft button (8)
to enter Zone Settings. Rotate the Encoder Knob to select Zone 1-4 and then
press the Encoder Knob to enter a Zone. Rotate the Encoder Knob to adjust
Zone volume. Press the Encoder Knob again to confirm the volume level.
Profiles
Press the soft button (2) to enter Profile Settings: Drive, Chill, Tow-Wake, Tow-Surf,
Tow-Ski.
8
UM2