Tuner Operation - Polk Mono UM2 Installation And Operation Manual

TUNER OPERATION

Tuner mode options available are Tune, Band, Preset and PTY.
BAND
Select a Band
Press the Band soft button to change between FM or AM bands.
TUNE
Manual Tuning
Press the Tune soft button. Press the |<< or >>| soft buttons to decrement/
increment stations down/up step by step.
Seek Tuning
Press and hold the |<< or >>| soft buttons to automatically seek the next or
previous strongest broadcast station.
PRESET
Preset mode options available are Autosave, Scan and List.
Autosave
Press the Autosave soft button to automatically select strongest stations and
store them in the preset list for the selected Band. The new stations replace any
stations already stored in that band.
Scan
Press the Scan soft button to scan stations stored in the current band list. The unit
will pause for ten seconds at each preset station. Press Scan again to stop
scanning when the desired station is reached.
List
Press the List soft button to display the preset list. There are 18 FM and 12 AM
preset locations to store your favorite broadcast stations.
• Store a Station
While tuned to the desired broadcast station, rotate the Encoder Knob (5) to
navigate the preset list and highlight the desired preset memory location.
Press and hold the Encoder Knob for 3 seconds or press the Save soft
button to store the station. The station frequency will appear in the display
adjacent to the preset memory location number.
• Recall a Station
Rotate the Encoder Knob to navigate the preset list and highlight the
desired preset memory location. Press the Encoder Knob to select and tune
to the corresponding stored station.
10
UM2