Table of Contents
Advertisement
INSTALLATION
Before You Begin
Always disconnect the negative battery terminal
Important Notes
x
Before final installation, test the wiring connections to make sure the unit is connected
properly and the system works.
x
Consult with your nearest dealer if installation requires the drilling of holes or other
modifications to your vessel.
x
Install the unit where it does not interfere with operating the vessel and cannot injure
passengers.
x
Use the included template to cut the installation opening.
Commander Cover
x
During storage, use the included cover to prolong the life of your device by protecting
the wired commander from direct sunlight, moisture, dust, and other elements.
Wired Commander Mounting
x
Choose a mounting area for the wired commander that is clean and flat, allowing the
rear gasket to fully seal to the mounting surface.
x
Secure the wired commander using either of the recommended mounting methods
detailed below.
Bracket Mount
x
Insert wired commander through cut-out and secure with bracket using included
hardware as detailed in the diagram.
Screw Mount
x
Secure the wired commander to the mounting surface using #6 stainless steel pan
head screws (not included) as detailed in the diagram.
Bracket Mount
Screw Mount
4
UM1A
Advertisement
Table of Contents
