Table of Contents
Advertisement
System Menu
Press and hold the Menu button (9) for more than 3 seconds to enter the
1.
system menu. "System Settings" will appear on the display, followed by the
first menu item, "Key Beep."
Rotate the Encoder Knob (5) to navigate the system menu and highlight the
2.
desired item.
Press the Encoder Knob to select the item and rotate the Encoder Knob to
3.
adjust the selected menu item.
Press the Encoder Knob again to enter your selection and return to the
4.
menu list.
Press the Swoop Arrow soft button (7) to return to the previous operation.
5.
The following items can be adjusted:
6.
•
Key Beep (On/ Off)
•
LCD Backlight (1 – 10), LCD Backlight Night (1 – 10)
•
LCD Contrast (1 – 10)
•
Button Backlight (1 – 10), Button Backlight Night (1 – 10)
•
Power Button Backlight (1 – 10)
•
Tuning Region (USA/ Euro)
•
SXM Satellite Radio (Sub Menu, only accessible in SiriusXM mode)
Set Lock Code
-
Locked Channels
-
SXi Firmware Version
-
•
Bluetooth Setup (Sub Menu, only accessible in Bluetooth mode)
Bluetooth On/ Off: Turn on and off BT module.
-
Bluetooth Device List (Lock/ Unlock, Disconnect/ Connect,
-
Delete): View, lock and delete from a list of previously paired
mobile devices.
Bluetooth Pair: Press Encoder Knob to confirm selection and put
-
the UM2 into pairing mode.
•
Battery Alarm (On/ Off)
•
Battery Auto Off (On/ Off)
•
Zone Toggle (On/ Off): When Zone Toggle is On, Zone Settings and
SUB volume are enabled in Audio Settings, and EQ Settings become
Profile Settings. When Zone Toggle is Off, Zone Settings and SUB
Settings are disabled in Audio Settings.
•
Reset to Defaults: Press Encoder Knob once to confirm. (Resets unit
to factory default settings)
•
About: Press Encoder Knob to view software version information.
NOTE: BT Pair and BT Device menu options are only available while in the
BT mode.
Battery Alarm Operation
If Battery Alarm is set to "ON", an alarm will sound (3 beeps every 30 sec) when
the voltage drops to 10.8V (+/- 0.3V). A visual warning (Battery Low) will appear
flashing on the LCD display.
NOTE: "OFF" is the default setting for Battery Alarm. If the audio is muted or
the volume is set to 0, the audible beep will not be heard.
Auxiliary Input
To access an auxiliary device:
Connect the portable audio player to the AUX IN cables routed from the rear
1.
of the radio.
Press the Mode button (6) twice to view the Auxiliary option.
2.
Press the Auxiliary soft button (8) to select auxiliary audio input mode.
3.
Liquid Crystal Display (LCD)
The current frequency and activated functions are shown on the LCD panel (10).
NOTE: LCD panels may take longer to respond when subjected to cold
temperatures for an extended period of time. In addition, the visibility of the
numbers on the LCD may decrease slightly. The LCD display will return to
normal when the temperature increases to a normal range.
Back Key (Swoop Arrow)
In various modes and conditions, the swoop arrow option will be available in the
lower right soft button (7). Press the button (7) to exit the current operation without
waiting for the system default time out and returning to the previous menu display.
9
UM2
Advertisement
Table of Contents
