Initial Setup Procedure; For Your First Lighting - Rec Tec Grills BULL RT-700 Owner's Manual

For your first lighting, follow this Initial Setup Procedure:
Before starting your REC TEC BULL, inspect the burn area inside
the grilling area. It is a recommended practice to go through the
1. Open the main lid and remove the stainless steel cooking grate, drip pan,
and flame deflector. Make sure all packing material has been removed.
2. Open the pellet hopper lid found on the back side of your grill and check
for any foreign objects.
3. Plug your grill into
the nearest 110 Volt
AC GFCI outlet.
4. Put no more than 1/2 cup of pellets directly into the fire pot to provide fuel
to burn while auger tube self-primes.
5. Pour pellets into your grill's pellet hopper.
6. Wash cooking grates with mild soap and water.
7. Reinstall the stainless steel flame deflector, drip
pan, cooking grates, and close lid.
During placement, be careful not
to damage temperature sensor.
8. Turn on your REC TEC BULL by pressing the power button at the left of the
panel. Set temperature to 400ºF by turning temperature control knob.
Questions? Call or check out our FAQ!
following procedure at initial start up.
If your home does not have a GFCI outlet, you
should have one installed by an electrician.
When lining drip pan, keep foil inside drip pan edges
and do not wrap around because this can restrict airflow.
9. Within a few minutes you will see smoke,
and your grill will light.
10. Once grill achieves 400ºF, allow it to
run for 1 hour; this will provide a final cure
and remove any residue that may have
accumulated during manufacturing and
shipping. After this initial burn, your grill is
ready for cooking.
Not ready to burn in?
19
Back to Table of Contents
Go Back to
Assembly
Tip: Many customers
line their drip pan
with aluminum foil
for easier clean up.
©2019, Rec Tec Industries, LLC