Tip: If you are planning on using your grill right away, save
time and begin your initial burn in here. Finish installing the
inner components while the grill begins to heat up.
Flame Deflector (#9), Drip Pan (#10) Cooking
Grates (#11), and Drip Bucket (#12) Installation
Open the lid of the REC TEC BULL. Install the Flame Deflector
(#9) over the Air Box Assembly with the small notches in the
Flame Deflector over the small tabs located at the inside front
and the large cutout to the rear of the grill body.
BE CAREFUL NOT TO DAMAGE THE TEMPERATURE
SENSOR WHILE INSTALLING THE DRIP PAN.
Questions? Call or check out our FAQ!
Initial Setup
Procedure
Air Box Assembly
14
Back to Table of Contents
©2019, Rec Tec Industries, LLC