Install Rtd Wires To Smart Grill Technology Controller; Plug Two White Braided Rtd Wires Onto Tabs Labeled Rtdpt1000 - Rec Tec Grills BULL RT-700 Owner's Manual

Install RTD Wires to Smart
Grill Technology
Locate the access panel underneath
the side shelf and open it by
removing the two screws. Feed the
two white braided RTD wires inside
through the grommet hole as shown
in Illustration 1.
Ensure all wire slack is
pulled into the side shelf.
Illustration 2
RTD
pt1000
Illustration 3
Questions? Call or check out our FAQ!
Controller
TM
Illustration 2
Plug the two white braided RTD wires onto
the tabs labeled 'RTDpt1000'
RTD
pt1000
Slide them firmly onto the connectors and be careful
to not touch any other parts of the circuit board.
Illustration 3
Replace the access door with the 2 screws.
Connect the wiring harness from under the
Smart Grill Technology™ controller shelf to the
grill body wiring harness. See Illustration 3.
Grommet
Illustration 2
RTD
pt1000
Illustration 3
Grommet
11
Back to Table of Contents
Tip: Use a 5/16"
or 8mm socket
wrench to remove
access panel.
Grommet
(Illustration 2)
©2019, Rec Tec Industries, LLC