Siemens CP 1243-8 IRC Operating Instructions Manual page 110

Approvals
IECEx
The product meets the requirements of explosion protection according to IECEx.
IECEx classification: Ex nA IIC T4 Gc
The product meets the requirements of the following standards:
● EN 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● EN 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
ATEX
The CP meets the requirements of the EC directive 94/9/EC "Equipment and Protective
Devices for Use in Potentially Explosive Atmospheres".
Applied standards:
● EN 60079-0
Hazardous areas - Part 0: Equipment - General requirements
● EN 60079-15
Explosive atmospheres - Part 15: Equipment protection by type of protection 'n'
ATEX approval: II 3 G Ex nA II T4
Test number: KEMA 10 ATEX 0166X
Over and above this, the following conditions must be met for the safe deployment of the CP;
see section Notices about use in hazardous areas according to ATEX (Page 38).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the supplied data medium with the
documentation.
For information on the EU declaration of conformity see above.
RoHS
The CP meets the requirements of the EU directive 2011/65/EC on the restriction of the use
of certain hazardous substances in electrical and electronic equipment.
Applied standard:
● EN 50581:2012
cULus
Underwriters Laboratories Inc. meets
● Underwriters Laboratories, Inc.: UL 508 Listed (industrial control devices)
● Canadian Standards Association: CSA C22.2 No. 142 (process control equipment)
110
Operating Instructions, 06/2015, C79000-G8976-C385-01
CP 1243-8 IRC