ABB UMC100-FBP Technical Description page 2

Universal Motor Controller
UMC100-FBP
Technical Description
Please note the following
Target group
This description is intended for use by trained specialists in electrical installation and control and automa-
tion engineering, who are familiar with the applicable national standards.
Safety requirements
The responsible staff must ensure that the application or use of the products described satisfy all the
requirements for safety, including all the relevant laws, regulations, guidelines and standards.
Using this Handbook
Symbols
This technical document contains markers to point the reader to important information, potential risks and
precautionary information The following symbols are used:
Abbreviations
UMC
DCS
PLC
GSD
EDS
FDT/DTM
NC / NO
FBP
Related Documents
Technical Documentation
DTM manual for FBP devices
Manual of the custom application editor
UMC100-FBP
Symbol to indicate a potentially dangerous situation that can cause damage to the
UMC or connected devices or to the environment
Symbol to indicate important information and conditions.
Symbol that indicates a potentially dangerous situation that can cause personal
injury
Universal Motor Controller
Distributed Control System
Programmable Logic Controller
Device description ile for PROFIBUS networks
Device description iles for DeviceNet networks
Device driver technology for ield devices. Speciied from the FDT group.
Normall closed / Normally open
FieldBusPlug is the name for a group of products which allows to connect ABB low
voltage control products to different ieldbusses.
Document No.
CDC 19 01 D0xx
CDC 135 014 D0xx
-  -
V 6
FieldBusPlug / Issue: 11.009