Communication Parameters - ABB UMC100-FBP Technical Description

Universal Motor Controller
UMC100-FBP
Technical Description
145 Autorestart
Delay
147 Enable Au-
torestart

Communication Parameters

Para-
meter
Number
17
18
-
-
IO Module Parameters
DX111 / DX122 Parameters
Param-
eter
Number
8
1
151
UMC100-FBP
Delay until the motor is restar-
ted
Enables the autorestart of the
motor after end of the voltage
dip
Parame- Description, Explanations
ter Name
Address Enable check if bus address stored in
check the UMC is the same as the one stored
in the FieldbusPlug.
Busfault UMC behaviour in the event of a bus
reaction fault.
Bus Fieldbus address. Depending on the
address FieldbusPlug used, the permitted ad-
dress range is smaller than the one
allowed here.
Parameter Prevents any parameter changes if set
lock to On.
Parameter Description, Explanations
Name
Missing Deines if the UMC creates a
Module fault or a warning in case of a
Reaction missing IO module.
DX1xx En- Specify if the module is con-
abled nected to UMC
DX1xx DI Input delay in ms assuming a
delay line frequency of 50Hz
0 ... 55s
Off (0)
On (1)
Options
Error (0)
Warning (1)
Off (0), On (1)
DX111: 3...00ms
Values are rounded up to the
next multiple of 3.
E.g.:
7,8,9 -> 9 ms delay
In addition to the software
delay a ix hardware delay of
about 4ms must be considered.
DX1: 3...00ms
Values are rounded to the next
multiple of 10. Values below 0
are rounded up to 0.
E.g.:
3...0: 0 ms delay
81...90: 90 ms delay
- 11 -
Options
Off (0), On (1)
Motor Off (0),
Retain (1),
Start For (),
Start Rev (3)
0,1,,3 ...55
Unlocked (0), Locked (1)
Adjustable via
All
All
All excluding
GSD-PDQ
FieldBusPlug / Issue: 11.009
V 6
UMC100-
PAN
PBDTM
UMC100-
PAN
PBDTM
Adjusta-
ble via
All
All
UMC100-
PAN
PBDTM
UMC100-
PAN