Table of Contents
Advertisement
tor between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last
fixture.
Power connection
Power Requirements
The Pioneer 100 zoom luminaire operates on 100 to 240 volts AC (+/- 10%, auto-ranging). The luminaire
contains an auto-ranging power supply.
Power linking between fixtures:
The fixture with powercon in and out socket. Connect the power out to the power in socket in the next fix-
ture till all are connected.
Caution: maximum power linking - 8 units.
Connection with the mains:
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection cables as below:
Cable color
Brown
Blue
Yellow/green
Operation
The Pioneer 100 zoom can operate different modes. In each mode you can run the fixture as a stand
alone fixture or in a master/slave confiugration. This next section will detail the differences in the operat-
ing modes.
Control Menu Map
MENU
Addr
CHnL
Strb
uL--
FL--
nodE
Id
tEnP
UErn
rSEt
pnnF
www.ovationlight.com
Connection
Live
Neutral
Earth(Ground)
SUB MENU
d001-d512
RDM/DMX address
2CH
3CH
Channel mode
4CH
5CH
S.01-s.20
Strobe with spead increasing
u.000-u.255
Dimmer
F.000-255
Zoom function
nod.0
Dimmer speed 0 (no delay)
nod.1
Dimmer speed 1
nod.2
Dimmer speed 2
nod.3
Dimmer speed 3
nod.4
Dimmer speed 4 (slowest speed)
Id.01-Id.66
ID address setting
-25~100
Fixture temperature
Firmware version
yes/no
Reset
(1.2~24.0)F
PWM refresh rate adjustment(KHz)
6
International
L
N
OPERATION
Version 1.0
Advertisement
Table of Contents
