Table of Contents
Advertisement
Installation
Read 'Safety information' before installing the fixture
The fixture is designed for indoor use only and must be used in a dry location with adequate ventilation. Ensure that
none of the fixture's ventilation slots are blocked.
Fasten the fixture to a secure structure or surface. Do not stand it on a surface or leave it where it can be moved or
fall over. If you install the fixture in a location where it may cause injury or damage if it falls, secure it as directed in
this user manual using a securely anchored safety cable that will hold the fixture if the primary fastening method
fails
Fastening the fixture to a flat surface
The fixture can be fastened to a hard, fixed, flat surface that is oriented at any angle. Ensure that the
surface and all fasteners used can support at least 10 times the weight of all fixtures and equipment to
be installed on it
Fasten the fixture securely. Do not stand it on a surface or leave it where it can be moved or fall over. If
you install the fixture in a location where it may cause injury or damage if it falls, secure it as directed
below with a securely anchored safety cable that will hold the fixture if the primary fastening method
fails
Mounting the fixture on a truss
The fixture can be clamped to a truss or similar rigging structure in any orientation. When installing the
fixture hanging vertically down, you can use an open-type clamp such as a G-clamp. When installing in
any other orientation, you must use a half-coupler clamp that completely encircles the truss chord.
To clamp the fixture to a truss:
1 Check that the rigging structure can support at least 10 times the weight of all fixtures and equipment
to be installed on it
2 Block access under the work area.
3 Fold the legs of the mounting bracket together and bolt a rigging clamp securely to the mounting
bracket. The bolt used must be M12. It must pass through both mounting bracket legs and be
fastened with a self-locking nut.
4 Working from a stable platform, hang the fixture with its clamp on the truss and fasten the clamp
securely.
5 Secure the fixture with a safety cable as directed below.
Securing with a safety cable
Secure the fixture with a safety cable (or other secondary attachment) that is approved for the weight of
the fixture so that the safety cable will hold the fixture if a primary attachment fails.
Loop the safety cable through the eyebolt in the back of the fixture and around a secure anchoring point.
Do not loop the safety cable around the fixture's mounting bracket only, as this will leave the fixture
unsecured if it separates from the bracket.
DMX-512 connection/connection between fixtures
Occupation of the XLR-connection:
4
Version 2.0
Advertisement
Table of Contents
