Table of Contents
Advertisement
A large plastic tank (round OR
square/rectangular) similar to a
trash can. Inside the tank is the
brine well—a small cylinder about 4
inches (10.1 cm) in diameter—which
contains the saftey float. The brine
not included )
tank holds the salt (
used for regeneration. There will
also be an overflow fitting and
tubing. Some systems may have a
salt grid—a plastic grid on the
bottom of the tank—but most do
not as they are not needed when
Brine Tank
using salt pellets as recommended.
DO NOT
This tank holds the salt,
LOAD THE RESIN IN BRINE TANK.
Depending on your order your
system will have either a single
piece stainless steel bypass or a two
part plastic bypass with yoke
connection. This is what connects to
your control head and provides
standard fitting connections to hook
up to your plumbing.
Bypass Valve
The flow meter connects the control
head and the bypass valve and it
measures the water flow to initiate
regeneration on demand. Includes
O-rings (already attached) to seal
the connection and screws and clips
to secure the connection. Typically
connected to the control head when
received.
Meter Assembly
4 of 28
Hide quick links:
Advertisement
Table of Contents
