Attach The Control Head; Lubricate The O-Rings; Inspect And Install Top Distributor Basket If Applicable; Screw On Control Head - AFWFilters Fleck 5600 Installation Instruction

Table of Contents

Advertisement

3—A
TTACH THE
3.1—Lubricate the O-rings DO NOT USE VASELINE
Img 3 - Tank O-ring
inside the control head and you will usually have to reach up inside to feel it. It is
very secure inside the head and almost impossible for it to come out. It is also a good
idea to verify that the riser tube fits snugly into the pilot hole and that the O-ring
seals around it.
3.2—Inspect and install top distributor basket if applicable
Img 5 - Top Distributor Basket
pointing down into the tank— Img 6 . Please note that
locking tabs hold it in place so a fair amount of force is needed to install or remove it.
3.3—Screw on control head HAND TIGHT ONLY
C
H
ONTROL
EAD
The tank O-ring— Img 3 —
seals the control valve to
the tank, and the pilot O-
ring— Img 4 —seals around
the riser tube. Verify they
are present and free from
nicks or kinks. Use a
silicone lubricant or
vegetable oil to both O-
rings. DO NOT USE
PETROLEUM BASED
LUBRICANTS! Please note
that the pilot O-ring is up
Depending on system
configuration your system
may include a top
distributor basket— Img 5 .
If your system includes one
it is recommended that you
use it. If you do not have
one then it is not needed. If
you do have one the larger
end will fit inside the
bottom of your control
valve, with the smaller end
sliding over the riser tube
9 of 28
Img 4 - Pilot O-ring
Img 6 - Attached Top Distributor
Basket

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for AFWFilters Fleck 5600

This manual is also suitable for:

Fleck 5600sxt

Table of Contents