AFWFilters Fleck 5600 Installation Instruction page 27

Cam
0 Sense
Error
Cycle Step
1
Error
Regen
2 regeneration
Failure
Circuit board
Memory
3
Error
Unplug the system, disconnect the piston
from the motor/gear, and verify that the
piston moves freely inside the valve; if it
spacers and possibly the piston is required.
After reconnecting the piston, inspect the
Piston took
more than 6
minutes to
reconnect any that are found. Perform a
advance
hard reset. After verifying programming
run the system through a regeneration and
moving the piston, if it is not the motor
needs to be replaced. If error still occurs
Unplug the system and check to ensure all
electrical connections and cam switches
are secure. Plug the unit back in and check
the master programming and ensure valve
Unexpected
type and system type are correct for your
cycle input
system. Initiate a manual regeneration
and verify it progresses through the steps
correctly. If error reoccurs, contact us for
More than
Perform a manual regeneration to reset
99 days
the error. Check your settings to ensure the
since last
automatically.
(7 on day of
the week
setups)
Perform a hard reset and go through the
memory
settings. If error occurs again contact us
failure
does not replacement of the seal and
control head for any broken, worn, or
disconnected parts, and replace or
watch the motor to ensure that it is
contact us for support.
support.
system is setup to regeneration
Check the meter to ensure
it is not stuck and that the gallons
remaining is counting down.
master programming to update the
for support
27 of 28