Table of Contents
Advertisement
RUGGEDCOM WIN5214
Installation Guide
Figure 4: Mounting the Antenna/Enclosure to a Small Pole
1. Pole
2. Clamping Bracket
Nut
8. M8-70 Hex Screw
4.
Adjust the position of the device. For more information about aligning the CPE antenna, refer to
"Installing the
Antenna".
5.
Tighten the screws connecting the clamping bracket to the mounting bracket. Make sure the screws are
torqued to 14 N·m (10 lbf-ft).
Section 2.1.2
Mounting the Device to a Wall or Tower
Attach the device to any wall capable of carrying the device's weight. An outer wall on a roof or other high
location to avoid interference from other buildings or trees is preferred.
Mounting the Device to a Wall or Tower
3
2
4
5
6
3. Mounting Bracket
9. M8 Spring Washer
7
4. M8-25 Hex Screw
5. M8 Flat Washer
10. M8 Flat Washer
Installing the Device
6
5
6. M8 Spring Washer
Chapter 2
1
2
8
9
10
7. M8
Section 2.2,
11
Advertisement
Table of Contents
