Table of Contents
Advertisement
Chapter 2
Installing the Device
IMPORTANT!
Install equipment in accordance with the electrical code relevant to the country of installation, such as:
• the National Electrical Code (NEC), ANSI/NFPA 70
• the Canadian Electrical Code (CEC), Part 1, CSA C22.1
• the National Electrical Safety Code IEEE C2 (when applicable)
Unless marked or otherwise identified, the Standard for the Protection of Electronic Computer/Data
Processing Equipment, ANSI/NFPA 75, also applies.
IMPORTANT!
Outdoor exposed communication lines longer than 40 m (140 ft) must be considered as TNV-1 circuits.
The installer must make sure the power supply and network ports are designed for full compliance with
the standards for TNV-1 telecommunication networks.
The general procedure for installing the device is as follows:
1. Mount the device to a pole or wall.
2. Install and connect the antenna.
3. Assemble the PoE cable.
4. Connect a RUGGEDCOM WIN1010 adapter.
5. Connect a RUGGEDCOM RP100/RP110.
6. If the device is to be installed in a hazardous location, install the Class I, Division II kit.
7. Make sure the device is grounded.
8. Weatherproof the ends of all cables.
9. Configure the device.
These steps, and other related information, are described in the following sections:
•
Section 2.1, "Mounting the Device"
•
Section 2.2, "Installing the Antenna"
•
Section 2.4, "Connecting the WIN1010 Data Adapter "
•
Section 2.5, "Connecting to a RUGGEDCOM RP100 or RP110 "
•
Section 2.6, "Installing the Device in Hazardous Locations"
•
Section 2.7, "Grounding the Device"
•
Section 2.3, "Assembling the PoE Cable"
•
Section 2.8, "Weatherproofing the Device"
•
Section 2.9, "Configuring the CPE"
Section 2.1
Mounting the Device
The RUGGEDCOM WIN5214 is designed for maximum mounting and display flexibility. It can be secured to a
bracket and then mounted to a pole or to a wall or tower.
8
RUGGEDCOM WIN5214
Installation Guide
Mounting the Device
Advertisement
Table of Contents
