Mounting The Devices With Device Connectors On A Wall - Siemens 340 Manual

5.8

Mounting the devices with device connectors on a wall

Requirements
Please note the following requirements for mounting on a level surface:
● Please observe the information about the mounting position in the chapter "Mounting
position (Page 56)".
● Two properly executed drill holes with thread or plug on the level surface
For details of the distances between the drilled holes, please refer to the relevant
dimension drawings in the chapter "Dimension drawings (Page 129)".
● Two screws to fit the M4 x 12 holes in accordance with DIN 784.
● Device connector
Please refer to the accessories list for the relevant order number in the chapter
"Accessories and order number scheme (Page 41)".
Procedure
Step
1 Push the device connectors together until they
engage.
2 Mount the cover on the left on the first device
connector in the system configuration.
The cover is included in the scope of supply of
the device terminator.
SIRIUS 3RM1 motor starter
Manual, 11/2013, A5E0345285095020A/RS-AB/002
Operating instruction
5.8 Mounting the devices with device connectors on a wall
Mounting
Figure
81